Cypress Semiconductor NoBL CY7C1472V33 Uživatelská příručka stáhnout pdf (Strana 7)

ZestSC1 User Guide

CONFIDENTIAL Page 7 of 57

standoffs in a position where it cannot touch any other items such as chassis,

boards or cables.

7. Plug the USB cable into ZestSC1 and the host computer or USB hub. It does not

matter whether the host computer is switched on or off. The cable has different

connectors at each end to ensure it is plugged in the correct way round.

8. If the host computer is switched off then switch it on now.

9. The host computer will detect a new USB device and request the software driver.

10. Install the software driver – see section 6.2 Software.

6.2.1 Headers

The connectors and headers on the board are listed below. Their approximate positions

are shown in Figure 1.

Figure 1. Approximate Positions of Connectors and Headers

Pin numbers zig-zag along the two-row header as shown in Figure 2.

Figure 2. Zig-Zag Pin Numbering of Two-Row Header

4 3

1 2 3 4 5 6 7 8 9 10 11 12 ... 56 57

Žádné komentáře

Cypress Semiconductor NoBL CY7C1472V33 Uživatelská příručka Strana 7